Symptoms:
While executing the Zerto Tools for Linux script, the warning(s) below may be seen and the script will continue forward:
Cause:
Each of the following drivers are required and validated at this step of the Zerto Tools for Linux script:
nvme, xen-blkfront, mptbase, mptscsih, mptspi, ena, ixgbevf
If any are missing, the aforementioned warning is seen for each missing driver and Failover/Move of the VM to AWS and can result in a failure.
Solution:
Workaround
For any missing necessary driver, install said driver by:
1] Add the driver name to /etc/dracut.conf file in the "add_drivers" section and save said file.
2] Run dracut -f -v to re-initialize.
3] Attempt the Move operation or wait for a checkpoint with a timestamp from after re-initialization to use for Failover.
NOTE: There is no need to re-run the Zerto Tools for Linux script for this particular validation warning after the above steps are followed.
Affected Versions:
Any
Hypervisor:
AWS, Azure, Hyper-V, VCenter